Power signal is introduced only four lines in accordance with the passive PoE 100 Mb/s, so that the device is completely compatible with the slower version of the LAN. PoE injector meet the power requirements of 12V to 56V.

Remote management over LAN switching PoE power on each output separately and automatic watchdog function. It monitors to communicate with devices on the specified IP addresses and failure to respond ICMP resets properly adjusted output PoE. This additional management option is realized by LAN Controller, which has led out on the front panel analog input, logic input and output relay - for use according to the needs of the user, eg. detection of opening cabinets, measuring the battery voltage, the inclusion of fan and so on. There is also a digital temperature measurement port on the bus 1wire with DS18B20 sensors. A practical solution is also the case of height and depth, and an optional 1U mounting bracket on the DIN-rail.

- Full bandwidth of 1 Gb/s

- Over-voltage protection on the input

- Overcurrent protection on the PoE outputs

- Management by www / SNMPv2

- Watchdog - reset PoE output

- 1 analog measurement input

- 1 measurement logic input

- Digital temperature measurement

- Assembly rack or DIN-rail

- Power cameras

- Industrial networks

- Smart home

PoE standard 4+, 5+, 7–, 8–

Supply voltage (terminal peg) 12 ÷ 56 V DC

Power consumption on a single PoE port maximum 1,5 A (recommended to 1 A)

Total current consumption on all ports ? 7 A

Reverse polarity protection YES

Output short-circuit protection YES 1,6 A

Operating temperature range –20 do + 65 °C

Dimensions (height x width x length) 45 x 78 x 170 mm (207 mm with holders)

Casing Type 1U with the option of mounting on DIN-rail

Weight 590 g